Wayland

Friday, September 7, 2012

Review/Build of Scibor Celtic Warriors

I have been running two Rune Priests in my Wolves army recently but using other models as proxies. GW do do a reasonable 'official' model and it wouldn't be too hard to scratch build one from spares. But Scibor also do some pretty awesome looking resin models...

Here's a few pictures and some tips on assembling Celtic Warrior and Celtic Warrior #2
.

 Here's what you get in the clamshell for Warrior 2. A nice scenic base, the body is one cast, and the right arm comes in three parts.

 Its not entirely compatible with GW's range of parts and models. The Scbior figures come with this rotary fan backpack, for example.

 All it took was trimming about a millimeter off the fan with a craft knife though, and a stock marine pack fits on quite neatly.

 The arm glues together quite easily too. Its important to have an idea of orientation before going to glue though. There are no guide marks like you might get on a Privateer Press model.

 Moving on to Warrior. This guy comes in four parts - the base, the body, and a sprue each for the arms. You might want to keep the arms separate until the glue is dry though as, again, there is no guide or mark to identify otherwise which shoulder pad goes with which shoulder.

 Is it a coincidence that the rifle the model carries is the weakest part of the whole sculpt? Well, maybe, maybe not, but its coming off. I chose to cut around the hanging talisman and then through the wrist to remove the gun.


  
Then a fist with a pistol was glued on to the stump.

The small number of parts and generally high quality of the casts made building and converting the Scibor models to GW style was really really quick and easy. The whole process took about half an hour. There are a few things to look out for though.

I was generally very impressed with the quality of the minis. Once the parts were carved off their sprues there was very little trimming to be done of excess flash. Zero mold-lines. And there were almost no bubbles. Warrior 2 was in fact free of them. Warrior did have a few little holes though. One on his right thumb, one on the haft of his axe and one on the underside of the butt of the same axe. I have used glue to fill them rather than greenstuff as they were all quite small and inconspicuous.


Aside from that, it is very important to use a sharp knife and lots of care when removing parts from the blocks of resin. The shoulder pads in particular are very firmly attached to the sprues. The thick resin was quite hard to cut through. This then means lots of force which means a greater risk of over-cutting both the model's parts and your own. Frankly I'm lucky not to have cut my thumb open last night.

In summary then, the two Scibor models I built and converted last night were of very high quality. Converting them to Space Wolf models is about as simple as it could be. The casts are great quality - both artistically and in production. These models will be a great addition to my Space Wolf army. Some care is need when cutting parts though.

I have added a few purity seals and nicknacks to the models and primed them. Later on I'll post some pictures of the painting.